Our redesigned GEN2 sliders are now ready for the world. These things are the literal definition of BEEFCAKE. GEN1 sliders were 149 pounds for the set, GEN2 are  double that. These are by far the strongest sliders for your 80 series available today. You will NOT be disappoint.

Lasercut, CNC bent, powdercoated (optional), and delivered to your door with all the necessary hardware, these sliders will take you anywhere.

Two of the many unique features are the modular, removable cat guards and step covers. Plenty of bolts to keep them in place (and your cats protected!), but easy enough to remove when it comes time to service your exhaust and components. The RIGHT side cat guard is for 1FZ engines and fit both OBDi and OBDii cat setups. The LEFT side cat guard is for 3FE engines. If you have an engine swap or custom exhaust that is all inside the frame rails, you don't need to add ANY cat guards, and you get the benefit of an even stronger setup. Plenty of cutouts for easy cleaning, it will be hard for them to collect mud and snow.

Below your cat guard (either side), you can add the SKID PLATE for extra, easy sliding protection. This gives you a full 1/2" of steel to slide over even the nastiest obstacles. There is nothing to attach this to if you are doing the inside the frame rail exhaust style, so don't add it to the cart.

Three (3) Hi-lift jack points on each side for secure and stable lifting of your vehicle.

Angled, planar surfaces to better slide over rocks, without snagging tubes and brackets.

For the daily use, built in stainless tread plates with custom formed dimples provide maximum traction in snow, rain, and mud. This will help you into the vehicle and give you a stable standing point for adjusting your roof loads.